I experienced some troubles though:
- Running the blinking example, the LED are blinking, but the outputs on the according screw terminal do not show any signal (Should be12 V, right?).
- Running the analog read example, the script always reads zero 0. I connected the A0 to the 12V of the supply, but still 0V. Then I tried to feed the 5V on the same screw terminal strip where the A0 is located, still 0V. Then I measured the voltages. The 5V header has no 5V and the ground has no connection to the ground of the device (Supply ground). Is it possible that all the upper screw terminal are disconnected from the board? I haven't opened the MAXI because of warranty etc. Strange is, that the LEDs seem to work
Thanks for your help