PWM output

Stuck? We'll be happy to help!
Post Reply
GA engineering
Posts: 1
Joined: Tue Dec 17, 2019 7:51 pm

PWM output

Post by GA engineering » Tue Dec 17, 2019 7:55 pm

Hello,

Are the pwm channels based on the input voltage (0-100% of input voltage eg. 24v) or is it only possible to go from 0 to 5v?

Thanks a lot!

User avatar
Jarda
Posts: 60
Joined: Fri Dec 14, 2018 10:52 am

Re: PWM output

Post by Jarda » Mon Jan 20, 2020 12:45 pm

Hello,
PWM outputs located at the screw terminals are related to the input voltage. If you need 5V only, you can use signals on the pinheader. Only please take into the account the implemented series resistance located to every pin on the pinheader. So connected capacitance must be low (or use some logic gate).

Regards
Jarda

Post Reply